You are here

4 posts / 0 new
Last post
legerlumber
legerlumber's picture
up and running

dragged a few logs into the shop left the overhead door and window open . saw seems to run nice other than a little vibration and a skip every inch and a half or so across the boards. im suspecting maybe a bad tooth .

Post Oakie
Post Oakie's picture

Sounds like a good start with your sawmill!  Bet you've got sawdust all over the shop, now.  It sounds like you are right on target about one bad tooth causing the skip.  It is probably next to the weld.  Look the teeth over carefully, and you may be able to adjust the offending one with a pair of pliers.  Keep us posted!

legerlumber
legerlumber's picture

dust wasnt too bad untill i forgot to put the tire and pail back on

legerlumber
legerlumber's picture

engine was out of line also